Estes FIRESTRIKE Manual De Instrucciones página 3

Note: Before charging the helicopter's LiPo battery after fl ying, always wait 10-15 minutes for it to cool down.
1. Pull the charge cord out from the left side of the
controller. (Pic 1).
2. Turn the controller switch to the ON position.
The GREEN LED should illuminate.
3. Carefully plug the charging cord into the
helicopter charge port. The controllers GREEN
LED will change to a bright RED. NOTE: DO NOT
FORCE the charge plug into the charge port.
4. The controllers RED charging LED will change to
GREEN when charging is complete (Pic. 3)
5. Remove the charge plug and turn the controller
OFF.
The helicopter can fl y for 4-5 minutes after 50-60 minutes of charging.
1. Set the infrared band
selector switch on the
controller to the same
letter found on the
bottom of helicopter.
2. With the throttle
(or left) stick of
controller in the
down position, move
controller's power/
charge switch to ON.
1. HOW TO TRIM:
• Gently move the throttle up to raise your helicopter about 1.5 feet (0.5 meter) to 3 feet (1 meter) high.
Spirals right or
Keeps turning right
If helicopter spirals to the right or keeps turning right, turn the
trim dial counter-clockwise until helicopter no longer spirals.
Helicopter Charging Procedure
Pic 1
Flying Your Helicopter
3. Move the
ON/OFF switch of
helicopter to ON.
Pic 2
4. Place helicopter
on the ground with
its tail pointing
toward you.
Spirals left or
Keeps turning left
If helicopter spirals to the left or keeps turning left, turn the
trim dial clockwise until helicopter no longer spirals.
LED
Pic 3
3