Front Panel - Alto Professional Radius 200 Guia Del Usuario

Belt-Pack Transmitter
Radius 200M instrument cable)
1 6
2
4
2
3 4 1
Mic Level
1: Ground
2: Line In
3: Mic In
4: +10V
Line Level
1: Ground
2: Line In
3: Mic In
4: +10V
Receiver

Front Panel

1. Power Button: Press this button to power the receiver on or off.
2. Display: This display shows the current channel, frequency, and other settings. See
more information.
3. Up/Down (): Press one of these buttons to select the different modes (Manual, Autoscan,
Preset). When searching for channels, press one of these buttons to move to the next-highest or
next-lowest channel, respectively.
4. Sync: Press this button to synchronize the receiver with the transmitter. See
more.
5. Set: Press this button to confirm your mode selection (Manual, Autoscan, Preset) or to set the
current channel. See
6. Volume Knob: Turn this knob to adjust the receiver's output level.
6
(for Radius 200H headset, Radius 200L lavalier microphone, or
1. Power/Mute Button: Press this button for 2 seconds to power
the transmitter on or off. Press this button briefly to mute or
unmute the transmitter.
2. Power/Mute LED: This light indicates the power or mute status:
•
Red light: The transmitter is on.
•
Flashing red light: The transmitter is low on battery
3
power.
•
Blue light: The transmitter is muted.
7
•
Flashing blue light: The transmitter is muted and low on
battery power.
5
3. Sync Button: Press this button to synchronize the transmitter
with the receiver. See
4. Display: This display shows the current channel and battery
power level.
5. Battery Compartment (not pictured): Insert 2 AA batteries into
this compartment. Make sure the polarities of the batteries (+ and
–) are correct.
6. Microphone/Instrument Input (mini-XLR): Connect the included
microphone or instrument cable to this input.
7. Gain Selector: Use this switch to set the gain of the audio input
to 10 dB, 0 dB, or -10 dB. For instruments with passive pickups,
we recommend setting this to -10 dB. For instruments with active
pickups, you may want to set this to 0 dB or -10 dB.
1
POWER
Operation to learn more.
Operation
5
2
3 4
to learn more.
6
Operation
Display for
to learn