dB Technologies ES 503 Manual Del Usuario página 28

English
Line input (CH1 /CH2)
The Line input channel strips allows the user to set the line input, adjust the level and set
the level assigned to the aux output (only in single column mode and stereo mode).
Here it's possible decide if the CH and CH will be managed in double mono mode
(selecting Mono item) or L/R Mode. The L/R mode is a simple autolink and routing to set
up the system in stereo mode. If the single column mode is chosen as setup and the
CH/CH are in L/R mode, the internal DSP will sum both channel.
Aux/Mix Output
The balanced AUX/MIX XLR output can be used as a simple mono link connection, to
relaunch part of the stereo mix to another speaker system (e.g.: right output to a second
ES), or to create a new mono mix with independent levels for stage monitoring or
recording purposes. This output is also provided with a second notch filter with selectable
frequency.
As in the others channel strips on board the left border is
dedicated do the input signal and the right border to the output
signal.
If this out is on AUX mode we can set:
AUX: Master level of the Aux output.
INST/MIC: Level of mic inst channel
CH/CH: Level of CH/CH.
This allows to create a different mix (in post fader mode)
dedicated to a recorder or stage monitor.
In this channel strips, when LINK is selected will be shown only
the Out level.
Holding pressed the rotary knob the menu will return to the main page.
From the main page, holding pressed the rotary knob will show you the
The Home Icon it's always displayed in the upper side of the OLED display

Tips & Tricks:
mixer volume page.