Maintenance And Cleaning; Waste Management - GALA Emotive Touch Manual De Instrucción Y De Usuario

MAINTENANCE AND CLEANING

hard
ANOMALIES DETECTION
If you have any anomaly in the bathtub, do
not allow anyone to intervene in its interior,
except the technical assistance service. Verify
the following anomalies table, and if
necessary contact a GALA distributer.
ANOMALY
No function is activated
Low pressure in the jet
ELIMINATION OF ELECTRIC
AND ELECTRONIC WASTE
At the end of its life cycle, the product must
be eliminated accordingly to the present
recycling regulation and it must not be
managed as usual urban waste.
The product ought to be eliminated in a
specialized recycling plant or returned to the
retailer in case it is replaced by an equivalent
product.
Symbol: it shows that the product complies
with the new policy requirements on
environmental protection (2002/95/CE.
2002/96/CE, 2003/108/CE) and it must be
correctly eliminated at the end of its life cycle.
Contact the legal authorities to obtain
information on the local of waste
management. The disrespect for the
requirements concerning the product
elimination indicated in this paragraph is
punished by law.
neutral
soft
POSSIBLE CAUSE
Energy failure
The differential switch or the thermo
magnetic relay was triggered
Water level too low
Blocked or broken engine
Misregulated level sensor
Closed regulator

WASTE MANAGEMENT

Put the empty packaging containing this
product in a recycling bin, by correctly
separating the diverse materials.
When the product is of no use anymore, do
not throw it away nor put it in the city
domestic garbage bins. Send it to the
authorized entities.
If you need any further information on the
entity to deliver it to, contact the local
services.
Most of the materials used to produce this
product are recyclable, so they may be part of
other new products or be used as raw
materials. It's up to you.
SOLU TION
Make sure there is power in the house
Put the switches in the position of
closed circuit (ON)
If it triggers again, do not turn it on
again; contact your distributer...
Fill the bathtub till the control emits a
flashing light
(fig.6, fig.13, fig.27, fig.35)
Contact the Service
Contact the Service
Open the regulator
(fig.4, fig.11, fig.25, fig, 33)
25