Troubleshooting - Impecca HSB100 Manual Del Usuario

MULTIFUNCTION BUTTON CHART
Function
Turn on
Pair
Turn off
Answer Call
End Call
Refuse Call
Play (Music Mode)
Pause (Music Mode)

TROUBLESHOOTING

See below for solutions to common problems.
Symptom
LEDs do not function
Connection failure
Sound is distorted
If you experience any issues that are not listed above, or if you are unable to resolve your issue after trying the
methods and solutions described above, please contact our technical support team:
Email: service@impeccausa.com
Visit our website: http://www.impeccausa.com
Button
Multifunction Button
Multifunction Button
Multifunction Button
Multifunction Button
Multifunction Button
Multifunction Button
Multifunction Button
Multifunction Button
Solution
Power button is not turned on. The battery is out of power.
Verify that the Bluetooth function of smart phone or other devices is
turned on.
Don't turn on too many headset and Bluetooth devices at the same
time when connecting. Please turn off other headsets and Bluetooth
devices in order to avoid interference.
Failed to pair successfully within 3 minutes. Please repeat the pairing
procedure.
Make sure the blue LED is flashing quickly (pairing mode)
Make sure the input password is correct (if required).
Check to see if the red LED is flashing (the battery is in low voltage).
Please charge the battery immediately
Check the volume and decrease the volume, if necessary. Be sure
that the Bluetooth device is within range. Move closer to the device
and see if sound quality improves.
Operation
Press and hold ( Approximately 5 seconds)
Press and hold ( Approximately 8 seconds)
Press and hold ( Approximately 5 seconds)
Quick Press
Quick Press
Press and hold (Approximately 5 seconds)
Quick Press
Quick Press
- 7 -