General Electric Lumination LDS Serie Manual Del Usuario página 5

Installation for Continuous Runs
A Starter Kit (SKU211994 - white or SKU211995 - black) is required
for continuous row installation. Kit contains:
A
Knockout plate
B
Starting cap
C
End cap
As the name implies, the Starter (if your product has such a choice) contains the beginning of the electrical connection. This means that this fixture
has the only Power Drop. The starter, when suspended, also is normally the only fixture in the row with (2) suspension hangers. The rest of
the run may be suspended from a single hanger (positioned near the end where the next fixture will connect).
Install the First Luminaire
1
Install starting cap on first luminaire
(cap towards knockout plate).
From 1st circuit:
From 2nd circuit:
(Black, White)
(Brown, Brown/White)
7
Access wires via knockout plate #2. Take
the unconnected power supply black
and white wires and connect them to
either the 1st circuit or 2nd circuit. Please
refer to wiring diagram in Step 9.
10
Wiring Note: The red line can be used for A/B switching by moving the black PSU input wire of "B" fixture to the red line. On a single circuit
that shares white neutral. Note that the black and red lines share the same neutral.
Optional branch circuit can be used for A/B switching by moving black and white PSU wires of "B" fixtures onto brown and brown/white lines.
On an additional circuit that requires its own neutral. Note that the brown/white is a neutral for the brown line.
For "EL" option code wiring see Emergency Light Supplement wiring diagram.
For additional guidance please refer to NEC 2014 Section 410.64 Part C - Wiring Supplying Luminaires Connected together.
The Starter & Continuous Run fixtures connect in rows
Knockout #2
2
Use starter kit knockout plate for
power drop-in at one of the
knockout locations #1 or #2.
Circuit 2:
(Brown, Brown/White)
From PSU:
(Black, White)
Knockout #2
Knockout #1
8
Once the driver is connected, you
can connect power from knockout
plate #1 or #2.
A
Starter Kit knockout
OR
Knockout #1
Circuit 1:
(Red, Black, White, Green/Yellow)
Dimming line:
(Violet, Grey)
B C
Groove
3
Follow Steps 3-6 from previous
section, Installation for
Independent Fixtures.
Line 2 Red (optional)
Line Black
Neutral White
Ground Green/Yellow
(0-10) + Violet
(0-10) – Grey
Line Brown
Neutral Brown/White
9
Connect wires based on wiring
diagram above.