Jam HX-EP900 BKB Manual De Instrucciones página 3

SET UP
CHARGING YOUR EARBUDS
To charge your earbuds, place them into the
portable case. The red LEDs show that they are
charging. If the red LEDs do not appear when
placed in the case, adjust the earbuds to make
sure they are in line with the charging contacts.
When fully charged, the LEDs will shut off.
CONNECT BOTH EARBUDS
STEP 1 – TURNING ON THE EARBUDS
Your earbuds will automatically turn on when
taken out of the portable charging case. If
you need to turn them on manually, you can
quick-press the "play/pause" button once on
both earbuds.
EN
x1
CHARGING YOUR PORTABLE CASE
Plug the small end of the micro USB cable into
the micro USB port, located on the right side of
the case. The LED on the case will show solid red
when charging. When the portable case is fully
charged, the LED will shut off.
STEP 2 – CONNECTING THE EARBUDS TO
EACH OTHER
When you take the earbuds out of their case,
they will automatically sync to each other, and
the LEDs will turn solid blue for 5 seconds. Your
earbuds will then go into pairing mode and begin
searching for a Bluetooth device, and the LEDs
will quick flash blue.
If your earbuds don't sync to each other
automatically, please check to make sure they are
charged and turned on.
Bluetooth
Devices
LIVE TRUE
STEP 3 – CONNECTING TO A DEVICE
Enable Bluetooth on your device. From the
Bluetooth menu, select "Live True." When the
device and Live True are connected, you will hear
a tone. This means pairing is complete.
3