General Warnings; Safety Warnings; Heater Description; Keyboard And Lcd Display - Haverland RCB Benjamin Manual De Instalacion Y Uso

0. GENERAL WARNINGS

* This thermal transmitter is an appliance to be fixed to the wall. Please read the explicatory instructions for its assemblage.
* This transmitter has been filled with determined quantity of special thermal fluid. For this reason the necessary reparations that need the
opening of the deposit or presence of any kind of escape should be undertaken by the manufacturer or by its Technical Assistance Service.
* Never pull the wire. Do not leave the connection wire in contact with the appliance while it is on.
* During its functioning, one must be careful to maintain the appliance far from combustible material such as curtains, carpets furniture etc.
*
DO NOT COVER THE APPLIANCE. DO NOT USE IT TO DRY CLOTHES. If it is covered there is an overheating risk.
* In order to prevent children from modifying the thermal transmitter programming, a safety blocking function is incorporated.
* DANGER: If the power supply cable is damaged, it should be substituted by the manufacturer or its Technical Assistance Service, or any
qualify personal.
* If the appliance is going to be installed in the bathroom, it should be put in such a way that nobody in the bathtub or shower should be
able to touch it.
* The appliance should not be located under or in front of a power supply socket.
* In order to disconnect the thermal transmitter from the mains power supply, unplug from the wall socket.
* Ensure that the thermal transmitter has been unplugged from the wall socket before carrying out any operation inside.
* At the moment of getting rid of these transmitters, the established rules for their treatment and recycling should be kept into account
(thermal fluid).
* The installation should be undertaken according to the correct rules regarding the electric installation.
* The appliance should have a ground connection.
* The appliance should be installed in such a way that the power supply plug should always be accessible.
* This transmitter should not be fitted in. Please respect the safety distance.
* The appliance is not intended for use by persons (incluiding children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of appliance by a person resposible for
their safety. Children should be supervised to ensure that they do not play with appliance.
* The transmitter CAN´T work with external programming devices or any other device of exterior control.
* The smoke from cigarettes, candles and incense burners combined with the effect of convection can cause stains on the wall. This is not a
failure the apparatus. Furthermore, the effect of sunlight or halogen may cause some discolouration in the apparatus.
* Temperature variations in the immediate environment of the device can generate "noise" and "clicks". Not a fault of the device.
* The guarantee of the appliance will not cover any damage caused by not reading and following carefully these instructions.

0.0 SAFETY WARNINGS

* Install the device in observance of all the laws, rules and regulations in force in the countries where installation takes place.
* II devices may have a black wire from the remote control pilot wire. If this wire is not used, it must be insulated and for no reason
earthed.
* The appliance should not be located under or in front of a power supply socket.
* Always disconnect the electricity supply from the mains before any maintenance operations.
* Check that the electricity supply system is connected through a Magnetothermic Circuit Breaker and a high sensitivity Residual Current Circuit
Breaker connected directly to the socket or connection box in use. A circuit breaker switch dedicated exclusively to the appliance is obligatory.
All contacts must be separated by a distance of at least 3 mm.

1. HEATER DESCRIPTION

1.1. KEYBOARD AND LCD DISPLAY

- RCB has four buttons and a display.
- ON/Stand-by button switches the regulator ON or puts it on standby: when RCB is on standby, the display shows a
ashing dot while when it is ON the display shows time and program in the chrono mode or the temperature setting in the
other modes.
Display
Function Button
Button +
Button -
Mode icon
Thermometer symbol
Button ON/Standby
ENGLISH
E
11