General Electric 29923 Guia De Inicio Rapido

LED Lantern
User's Guide
battery installation:
The lantern is operated with 6 D cell batteries (not included). Batteries must be installed or replaced in sets of six.
NOTE: If replacing the batteries, remove the old batteries and follow the instructions below.
1. Turn the lantern over and remove
the battery cover by twisting the cap
counter clockwise.
2. To run the lantern from 6 D cells, fill
all six positions noting proper battery
polarity.
using the latching handle:
illustration 1
1. To open the handle, depress the raised
button near the bottom of the handle. See
illustration 1.
2. Fully open the handle.
3. Close handle around object you wish the
lantern to hang from. See illustration 2.
4. Open the raised button. Be sure the handle is
securely latched before allowing lantern to
illustration 2
fully hang on its own. See illustration 3.
• Do not attempt to hang lantern with
handle in open position.
• Always be sure to hang the lantern in a
safe and secure area.
• Lantern should never be left out in
excessive wind.
usb charging:
Rating: 1A@5V
USB charging port may not charge all devices. Some
devices require a proprietary USB power supply.
3. Replace the battery cover by fitting the
center plastic column within the base
and then twisting the cover clockwise
until it clicks firmly into place.
illustration 3
29923 ver2 12/16
CAUTION
BATTERIES MAY LEAK HARMFUL LIQUIDS OR
IGNITABLE MATERIALS OR EXPLODE CAUSING
INJURY OR PRODUCT DAMAGE.
• DO NOT MIX OLD AND NEW OR OTHER
BATTERY TYPES
• REPLACE ALL BATTERIES AT THE SAME TIME
• REPLACE FULLY DISCHARGED BATTERIES
IMMEDIATELY
• REMOVE BATTERIES IF PRODUCT IS TO
BE UNUSED FOR EXTENDED PERIOD OF TIME
FCC statement
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
FCC NOTE: The manufacturer is not responsible
for any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modifications could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures: reorient or relocate the receiving
antenna, increase the separation between the
equipment and receiver, or connect the
equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Made in China
GE is a trademark of General Electric Company
and is under license by Jasco Products Company
LLC, 10 E. Memorial Rd., Oklahoma City,
OK 73114.
This Jasco product comes with
a 5-year limited warranty.
Visit www.byjasco.com for details.
Questions? Contact us at 1-800-654-8483
between 7:00AM—8:00PM CST.