Quick QCC DRV 4CH 350 Manual De Instalacion Y Uso página 28

CHARACTERISTICS / INSTALLATION / OPERATION
EN
INTENDED USE
• The QCC-DRV 4CH 700 is intended to be used to control colour and adjust the brightness of RGBW LED light sources; as
well as to control colour temperature, and adjust the brightness of dynamic white light sources (TW) and white single-
colour light sources, via 4 constant current outputs.
• For fire-prevention reasons, install the QCC-DRV 4CH 700 in a ventilated, controlled-temperature environment, protected
from dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Always provide a fast-working 3A fuse on the device's power supply to protect its electronics.
• Any other use should be considered improper and unpredictable.
F
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
IN CASE OF DOUBT, CONTACT YOUR DEALER OR QUICK
THE PACKAGE CONTAINS: QCC-DRV 4CH 700 - RJ45 line terminator - conditions of warranty - the manual of
installation and use.
TECHNICAL ELEMENTS AND DEFINITIONS
• RGBW light: red, green, blue and white light source.
• Tunable White (TW): warm and cold white source light.
• Control signal: In this specific manual, it is the electrical signal generated by the QCC-PLT 300 and which contains the
necessary information for the QCC-DRV 4CH 700 driver operation.
PRODUCT DESCRIPTION
The QCC-DRV 4CH 700 is a module to adjust light intensity and colour in a QCC system.
This function is active only if the device is coupled and appropriately connected to Quick
INSTALLATION
• The device must be placed in a suitably protected distribution board so that it can operate under the environmental
conditions indicated in the general specifications for use, and is not within reach of personnel who are not qualified.
• Always disconnect the supply voltage during installation and maintenance operations.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
OPERATION
The QCC-DRV 4CH 700 receives the power supply and the 2-wire BUS control signal without polarity from the QCC-PLT 300
at its input and provides 4 channels of constant current at its output.
Two models of constant current drivers are available, the QCC-DRV 4CH 700 and the QCC-DRV 4CH 700 with the following features:
DRIVER
Maximum constant current
for each channel
Compatibility
Carico massimo
Wiring, terminals and cables
Considering the high currents involved, a few precautions on wiring are in order:
• The maximum length of the wires used for the control signal (2 cables bus without polarity) is 100 metres (328'); use
cables with a maximum cross section of 2.5mm
• To connect the QCC-DRV 4CH 700 to the RGBW LED light sources, use shielded Ethernet cables (FTP), type CAT5e and
with *RJ-45 male-to-male connector.
• The maximum length of the connection to the lights, with RJ45 extensions, is 25 metres (82').
* The RJ-45 male-to-male connector is not supplied together with the QCC-DRV 4CH 700.
QCC-DRV 4CH 350
350 mA
6W QCC RGBW and TW downlights
up to 3 @ 12V - up to 6 @ 24V
(0,1') suitable for the load applied.
2
8
CUSTOMER SERVICE.
®
QCC-PLT 300.
®
QCC-DRV 4CH 700
12W QCC RGBW and TW downlights
QCC-DRV 4CH 700 - REV001A
700 mA
up to 3 @ 24V
QUICK SPA