Environmental Protection - RHINO 501066 Manual De Instrucciones

MULTIFUNCTION TOOL SET 170W + 120ACCESSORIES
Caution! Read the note of use before using this product
double insulation = Class II
To wear protectors of ears at the time of the use of the apparatus; Noise exposure can cause a high loss of
hearing.
Use a mask anti-dusts if the operations of cup pull dusts
Wear glasses
Wear gloves

ENVIRONMENTAL PROTECTION

In accordance with directive 2012/19/EU, when this product arrives at the end of the lifetime, not to throw
with the household refuse. Please bring back it to the manifold centre nearest to on your premise so that it is
reprocessed. By carrying out this gesture, you contribute to the environmental protection.
1 - Characteristics
Power supply: 230 V ~ 50 Hz
Power rating: 170 W
Speed: 8000 – 35000 / min
Insulation: Class II
Maximum chuck capacity: 3,2mm
Vibration value: 3,74 m/s
Sound pressure level: 72,5 dB (A) +/-3 dB
Acoustic power level: 83,5 dB (A) +/-3 dB
2 - General introduction
This multifunction tool is intended for minor milling, drilling, engraving, sculpture, polishing, sanding and cleaning work
involving metal, concrete, wood and other materials.
This multifunction tool may be connected to sockets without protective circuit breakers because it is fitted with double
insulation. Ensure that the mains voltage corresponds to that indicated on the information plate (230V~ 50Hz). Make sure
that the power cord is in a good condition.
Respect the following advice:
-
Remove the power plug from the socket before carrying out any adjustment, maintenance or repairs.
-
Do not subject the machine to sudden changes in temperature, which may cause water vapour condensation to form
on the surface of the insulation.
-
When assembling or disassembling tool or the chuck, disconnect the machine by unplugging the plug from the power
socket.
-
When using the machine, ensure that the work piece is securely held in the chuck or in any other clamping device.
3 - Electronic speed regulator
This multifunction tool is equipped with a knob that enables the speed to be adjusted.
4 - Using the shaft locking button
This multifunctional tool is equipped with a shaft locking button situated at the back of the chuck, which makes it possible to
tighten or loosen the chuck by hand.
Fitting a chuck bit
Press on the shaft locking button, unscrew the chuck ring completely, remove the chuck bit, place the new bit into the
chuck, tighten the chuck and release the shaft locking button.
Fitting a tool
Press on the shaft locking button, loosen the chuck ring by a few turns, put the tool in place, after having fitted the
appropriate chuck, fully tighten the chuck ring and release the shaft locking button.
GB
REF.: 501066
INSTRUCTION MANUAL
2 +/- 1,5m/s²
501066
GB
Page 1 sur 2