11. Maintenance; Recommended Lubricants/Oil Mist Lubricator; Cleaning And Servicing; Service Intervals - Sicam SBMV955 Manual Original

11. Maintenance

11.1 Recommended lubricants/oil mist
lubricator
Component Lubricant
Compressed air system ESSO FEBIS K 32
Tab. 2: Lubricant table
!
The manufacturer cannot accept any liability for da-
mage arising from the use of other lubricants.
11.2

Cleaning and servicing

!
Before cleaning and servicing, switch off SBMV955
and disconnect mains plug.
!
Do not use any solvent-based cleaning agents. Use
alcohol or similar cleaning agents for plastic parts.
The following work is essential to ensure proper opera-
tion and high performance of the SBMV955:
11.2.1

Service intervals

Servicing
Clean moving mechanical parts, treat with spray oil
or kerosene and lubricate with engine oil or
a suitable grease.
Remove condensate.
Check the oil level in the oil mist lubricator.
Replace the oil in the oil mist lubricator.
Tab. 3: Service intervals
11.2.2

Removing condensate

1. Turn the red knob at the bottom of the water separa-
tor counter-clockwise.
2. Remove the accumulated condensate.
3. Turn back the red knob at the bottom of the water
separator.
Sicam snc società unipersonale
11.2.3
1. Remove the compressed air connection.
2. Screw the container to the oil mist lubricator.
3. Top up with oil.
Standard
ISO 32
11.2.4
1. Remove the compressed air connection.
2. Screw the container to the oil mist lubricator.
3. Drain off and dispose of the oil.
4. Fill with fresh oil.
11.3
The manufacturer does not accept any liability for da-
mage arising from risks associated with the malfunctio-
ning of non-genuine replacement parts.
x
Designation
Standard centering flange
x
Clamp
x
Centering cone 42 - 64,5 mm
x
Centering cone 54 - 79,5 mm
Centering cone 74 - 111,5 mm
Weight pliers
Manual vernier caliper
Test clip
Calibration weight
Calibration weight (calibrated)
Voltage sticker
Direction of wheel rotation sticker
Tab. 4:
Maintenance | SBMV955 | 47

Topping up oil in oil mist lubricator

Replacing oil in oil mist lubricator

Replacement and wearing parts

Replacement and wearing parts
en
Order number
636 500
653 212
632 500
652 862
605 600
606 500
629 400
652 870
654 377
654 376
100 789
653 878
| |
656 407 2010-11-22