Bentel Security AMB10 Manual Del Usuario página 13

AMB10 - 15 - 20
c) set to OFF employed beam "BEAM" dip switches in the SLAVE card.
12VDC-
powering
terminal strip
Select desired alarm mode of intrusion detection with "FUNCTION" 1 and 2 dip switch of the Master and Slave
Alarm Triggering
Dip 1
ON
ON
OFF
OFF
N.B.: DIPs 3 and 4 are not currently operative and are available for future applications.
5.3 Warning buzzer to indicate flat battery
When the voltage threshold of 3.0 V is reached, the MASTER barrier starts to give out a beep every 3 hours.
After 3 days, the beep will sound every hour.
After a further 3 days, the beep will sound every 15 minutes until the batteries are completely flat.
In any case, the flat battery beep is given out each time that the beams are interrupted, with a consequent renewal of the
signalling period.
Off-board 3.6V power pack
connector
Radio Alignment
Button
NO TMP1 opening protection
DIP SWITCH BEAM
ON
Beam
enabled
OFF
DIP SWITCH FUNCTION
ON
OFF
Mode
Dip 2
ON one beam break-off for at least 0.3 seconds
OFF one beam break-off for at least 0.9 seconds
two beams break-off for at least 0.3 seconds
ON
two beams break-off for at least 0.9 seconds
OFF
ENGLISH
AA 3.6V 2.7Ah
battery
Reset button
jumper
NO TMP2 tear-off
protection jumper
1 2 3 4
1 2 3 4
Intrusion detection
13
ISFSLIMRFWL_05_08.doc
RADIO module
Beam enabling DIP
BEAM dip switch
Alarm mode selection DIP
FUNCTION dip switch
Beam
disabled