Head/Accessory Installation Instructions - OHAUS VXHDAL Manual De Instrucciones

a i i
ccessory nstallation nstructions
Installing the cup head, microplate trays, universal holder or other head
attachments:
1. Move the 3-way rocker switch to the center, off/standby position.
2. Place accessory on head mount of the unit, aligning the square on the bottom of
the accessory with the square on the top of the unit. Lower accessory until it is
sitting on the head mount.
3. Turn the accessory counter-clockwise until it snaps into place (approximately
1/8 of a turn). Add samples to attachments after the accessory is secured onto
the Vortex Mixer. Be sure samples are secure before turning unit on.
4. To remove an installed accessory, move the 3-way rocker switch to the center,
off/standby position. Turn the accessory clockwise (approximately 1/8 of a turn)
and then lift the accessory straight up. Remove samples before removing the
accessories.
• T o load a microplate into the microplate tray, position the microplate against
the foam bumpers first, then push down the other side to ensure a secure fit.
To release a microplate, push it against the microplate tray's foam bumper and
lift to remove.
• M aximum speed may vary when vortexing microplates. Speed may be
dependant on the height of the skirt on the microplate or material of the
microplate.
• R ubber vibration dampeners on the bottom of the microplate tray and universal
holder may need to be reinserted into the proper position when vortexing at
high speeds. Squeeze firmly as you maneuver it back into position.
(a u )
ll nits
a i i
ccessory nstallation nstructions
Installing the vessel holders:
1. Attach the Universal Holder to the vortex mixer.
2. Place the Grip Mat in the bottom of the Universal Holder.
3. Place the flask on top of the Grip Mat, in the center of the holder.
4. Pull the center hole of the Vessel Holder over the sample container.
5. With the arrow on the Vessel Holder close to the front of the unit, the straps
should line up with the posts of the Universal Holder.
6. Push the hole on the strap over the posts on the holder. Secure the strap so
that it fits into the slot on the holder. Repeat this for the remaining two straps.
7. Be sure the sample is secure before turning unit on.
Installing the Universal Holder Cover:
1. Place the Foam Insert into the Universal Holder.
2. Lay the Universal Holder Cover on top of the foam, and align the edges.
3. Push the hole on the cover down over the post on the holder. Squeeze the
strap so that it fits into the slot on the holder, leaving the cover sitting flat on
the foam. Repeat this process for the remaining two posts.
4. To remove the accessory cover, secure the straps and pull straight up.
EN
(H d v m )
eavy uty ortex ixer
8