Farelek 112500 Manual De Instrucciones página 46

2
Drilling in the wall
Mark the position of
the holes and then
drill 65 mm holes in
the wall.
3
Connections
1 - Open the front panel.
2 - Remove the screw from the cover of the elec- 2 - Remove the screw from the cover of the elec- 2 - Remove the screw from the cover of the elec- 2 - Remove the screw from the cover of the elec-
tric board of the unit and set it aside.
3 - Remove the fixation screw and put it aside. 3 - Remove the fixation screw and put it aside. 3 - Remove the fixation screw and put it aside. 3 - Remove the fixation screw and put it aside.
4 - Connect the cable.
5 - Replace the fixation and cover of the electric 5 - Replace the fixation and cover of the electric 5 - Replace the fixation and cover of the electric 5 - Replace the fixation and cover of the electric
board.
Internal unit terminal
112500-504-E
Insert the rule
Align the rule carefully
Schéma Schéma Schéma Schéma
Screw
Connection cable Connection cable Connection cable Connection cable
© FAR GROUP EUROPE 2004
46
18 0m m
18 18
10 10
Center of the hole ( ø 65mm) Center of the hole ( ø 65mm) Center of the hole ( ø 65mm) Center of the hole ( ø 65mm)
Internal unit terminal Internal unit terminal Internal unit terminal Internal unit terminal
Insert fully the wire of the
connection cable
Connection cable
24/01/05, 11:37
GB
Screw
Pin