Controls & Features - Cub Cadet 19B40026100 Manual De Operación

11. When the tailgate is in position, secure it in
place by snapping the tailgate latches onto
the tailgate. See Figure 3-8.
Figure 3-8
12. Remove the clevis pin and the cotter pin
from the hardware pack.
Controls & Features
Tailgate Latch
NOTE: References to LEFT, RIGHT, FRONT, and REAR
indicate that position on the hauler when facing
forward while seated in the tractor's operator seat.
Tailgate
The tailgate is located on the back of the hauler
and can be opened for loading and locks into
place with the use of the two tailgate latches.
6
1
3
13. Slide the tongue assembly into the tongue
bracket as shown in Figure 3-9. Line up the
rear-most hole with the hole in the tongue
bracket and insert the clevis pin through the
tongue assembly and the tongue bracket.
Secure the clevis pin with the cotter pin as
shown in Figure 3-9.
Tailgate Latch
Tailgate
Tailgate Latches
The tailgate latches are located on the rear of the
hauler and are used to secure the tailgate.
Tongue Hitch
The tongue hitch is located on the front of the
tongue and is used to hook the hauler up to your
tractor.
2
Figure 3-9
14. Be sure that the clevis pin is installed on
the interior of the tongue assembly and
the tongue bracket as shown in the inset in
Figure 3-9.
Checking Tire Pressure
Warning! Equal tire pressure should
be maintained at all times. Refer to
the tire sidewall for proper pressure.
The tires on your hauler may be over-inflated for
shipping purposes. Adjusting the tire pressure before
using the hauler may be required. Check the sidewall
of tire for maximum p.s.i.
NOTE: The recommended tire pressure is 14 p.s.i.
Dump Pedal
Tongue Hitch
Dump Pedal
The dump pedal is located on the tongue and can
be used to dump the contents of the hauler.
4