Top Panel - ION PROJECTOR PLUS Guia De Inicio Rapido

Features

Top Panel

9
3
1
2 6
1. Power Button: After powering on Projector Plus (via the Power Switch on the side panel), press
this button in order to enter or exit standby mode. In standby mode, Projector Plus will not be
fully turned off but it will save battery life.
Note: When Projector Plus is out of standby mode and fully powered on, the speaker will work,
but you will need to use the Projector On/Off button to turn on the projector.
2. Projector On/Off: Press this button to turn the projector on or off.
Tip: This feature can be useful for saving battery life. If you are only using Projector Plus to listen
to music from a Bluetooth or auxiliary device, use this button to turn the projector off and save
Projector Plus's battery.
3. Bluetooth Button: Press and hold this button to make Projector Plus unpair from a connected
Bluetooth device and automatically search for another Bluetooth device to pair with. The
Bluetooth button is only for unpairing connected Bluetooth devices, since Projector Plus is
always in pairing mode.
4. Echo Button: Use this button to turn the Mic Input's echo effect on or off.
5. Source Button: Press this button to determine the source of video played by Projector Plus: the
USB Port or HDMI Port.
6. Menu Button: Press this button to access the projector's picture settings. Then use the Arrow
buttons and OK button on the Navigation Pad to adjust the settings.
7. Return: When using the projector, press this button to go back one page.
8. Navigation Pad: Use the buttons here to navigate pages and select/adjust settings for your
projector. Use the Arrow buttons to highlight/edit different options and the OK button to make
a selection.
9. Status LEDs: From left to right, these four LEDs are the:
•
Standby LED: This LED will be off when Projector Plus is powered off, lit red when Projector
Plus is powered on, and lit green when Projector Plus is powered on but in standby mode.
•
Bluetooth LED: This LED will be lit blue when Projector Plus is paired with a Bluetooth audio
source.
•
Echo LED: This LED will be lit red when the mic echo effect is turned on.
•
Battery LED: This LED will blink red when Projector Plus has a low battery. It will be lit solid
when Projector Plus is connected to power and charging (solid red when the unit is still
charging; green when the unit is fully charged).
4
4
7
5
8
11 10