Putting On The Headset; Turning The Headset On And Off; Adjusting The Sound Amplification; Noise Attenuation (According To The Standard En 352-1: 2002) - Num'axes CAS1034 Guía De Uso

Putting on the headset

The headband has two independent settings. Tighten the headband then adjust it until the cups are
correctly positioned on your ears. For maximum efficiency, the headband must be perfectly adjusted and
the ear pads must provide a perfect seal over your ears.
Tip: remember to slacken your headset before taking it off.

Turning the headset on and off

To turn your headset on, simply turn the button ON/OFF in a clockwise direction. A light "click" will tell
you that you have just turned the headset on. The red led situated on the right cup turns on.
To turn off your headset, turn the button in an anticlockwise direction. A light "click" will tell you that
you have just turned the headset cup off. The red led situated on the right cup turns off.

Adjusting the sound amplification

To amplify the sound, once your headset is turned on, simply continue turning the button on each cup in
a clockwise direction.

Noise attenuation (according to the standard EN 352-1: 2002)

On average, the NUM'AXES headset attenuates noises that are dangerous for your hearing by 29 dB.
Minimum Sound Attenuation (according to the standard EN 352-1: 2002)
SNR = 29 dB H = 33 dB M = 26 dB L = 18 dB
CAS1034 – ind.A – Avril 2018 13/44