Maintenance
CARTRIDGE REPLACEMENT
To replace the cartridge, please follow these steps:
1 . Turn off the water supply to the faucet .
2 . Remove water indicator (15) and set screw (16) with a hex key .
3 . Remove the handle (17) .
4 . Unscrew the cartridge cover (18) .
5 . Remove the washer (19) .
6 . Pull out the cartridge (20) by hand, make sure gasket (21) and
spring (22) remain in the faucet .
7 . Install the new cartridge .
8 . Place the washer (19) back in its original position .
9 . Secure the cartridge cover (18) . Do not over tighten .
10 . Place the handle (17) over top and secure the set screw (16)
with a hex key, reinsert the water indicator (15) .
Care and Cleaning
This utility sink is manufactured with premium ABS . With the proper care and maintenance it will provide you with many years of enjoyment .
SINK
Do
- Use common household cleaners (non-abrasive) or a
mild liquid dish washing detergent . Rinse well and dry
with a clean cloth .
- Remove dust and dry dirt with a soft, damp cloth .
- Clean grease, oil, paint and ink stains with isopropyl
(rubbing alcohol) . Immediately rinse with water after
removal of stain .
Do not
- Do not allow your ABS surface to come into contact
with products such as acetone (nail polish remover),
nail polish, dry cleaning solution, lacquer thinners,
gasoline, pine oil, etc .
- Use caution when using sharp instruments that may
fall and scratch the surface .
QL642
CABINET
Do
- Remove dust and dry dirt with a soft, damp cloth .
- Clean grease, oil, paint and ink stains with isopropyl
(rubbing alcohol) . Immediately rinse with water after
stain removal .
Do not
- Do not allow your cabinet surface to come into
contact with products such as acetone (nail polish
remover), nail polish, dry cleaning solution, lacquer
thinners, gasoline, pine oil, etc .
- Use caution when using sharp instruments that may
fall and scratch the surface .
10
Handle (17)
Set Screw (16)
Water Indicator (15)
Cartridge Cover (18)
Washer (19)
Cartridge (20)
Gasket (21)
Spring (22)
Faucet Body (23)