Safety Precautions - Easy-Laser D160 BTA Manual

LASER SECURITY
This is a laser instrument in laserclass II with an
output power less than 1 mW, which only requires
the following safety precautions:
Never stare directly into the laserbeam.
Never aim the laserbeam to anyone elses eyes.
NOTE! Opening the laser units can result
in hazardious radiation, and will break the
manufacturer warranty.
NOTE! The instrument should not be used in
explosive risk areas.
DISCLAIMER
Damalini and our authorized dealers will take no
responsibility for damages on machines and plants
as the result of the use of the instrument.

SAfETY pRECAUTIONS

Warning! If starting the machine that will be
measured can result in personal injuries, the possi­
bility to unintentially start it shall be disabled before
mounting the measurement equipment, for example
by locking the switch in off position or remove the
fuses. These safety precautions should remain until
the measurement equipment are removed from the
machine.
fEATURE
Attach to non magnetic sheaves.
Because of the light weight of the transmitter and
the detector you can also mount the units onto non
magnetic sheaves by attaching pieces of double
sided adhesive tape to the magnetical surface. Be
sure that both the surface and the sheaves are
cleaned from grease and oil before attaching.
CARE
Clean the units and the windows at the apertures
with a dry cotton cloth. If not using the system for a
long period of time, remove the batteries.
LASER TRANSMITTER
Laser aperture
Magnetic area
DETECTOR UNIT
Connector
Magnetic area
TARGETS
Battery Alkaline
1xR6 (AA) 1.5 V
Detector aperture
CABLE