Wattio THERMIC Manual Del Usuario página 35

1. Remove the old thermostat.
2. Screw the back cover to the wall.
NOTICE: we recommend not forcing the plastic case by tightening
too much the fasteners for the correct performance of the
Thermic.
Proceed to the introduction of the wires in the terminal block.
Cables should be about 1cm peeled in their termination.
The general cable must be identified and inserted into port 3.
To insert the cables, you have to press buttons in enabling the terminal with a screwdriver. Once
inserted, stop pressing and the cable will be properly inserted.
35