Installation And Operation; Start-Up - Bartscher STM3 Instrucciones De Uso

5. Installation and operation

5.1 Start-up

CAUTION!
The device may be operated only by the authorized and properly trained
personnel, having sufficient technical experience.
Before switching the device on:
thoroughly read the technical manual;
-
become familiarized with the safety and protective devices,
-
as well as their locations and mode of operation.
The use of the device parts and its components designed for safety and protection
by unauthorized persons may cause malfunctions or hazards for the operator.
The operator must be properly trained, informed about the residual risk and
correct operation of the device.
Assembly / Disassembly
WARNING!
All operations related to the assembly / disassembly
of each device part must be performed with motor
turned off and plug removed from the socket.
Assembly of appropriate equipment element to the motor block is realized according to
the instructions below.
Beater
1. Put the retaining flange (
10
beater ( ) on the quick coupling (2)
of device body (1).
2. Tighten the beater (10) to the quick
coupling (2) of device body (1).
- 42 -
12
) of
2
10
1
12