Introduction; Proper Use; Delivery Contents; Component Description - Tronix T4X SE Instrucciones De Utilización Y De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Introduction

The following pictograms are used in these operating instructions / on the device:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Danger to life!
Risk of explosion!
Risk of fire!
Battery charger T4X SE
Introduction
Q
P lease carefully read these operating
instructions and fold out the page with
the illustrations. Keep these operating
instructions in a safe place and hand them over to
anyone to whom you pass on the appliance.

Proper Use

Q
The TRONIC T4X SE is a battery charger with a
pulse trickle charge mode and is suitable for charg-
ing and maintenance charging of the following 6 V
or 12 V lead rechargeable batteries with wet cell
or gel electrolyte:
6 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 14 Ah to 120 Ah
You can also used it to regenerate completely dis-
charged batteries. The battery charger has protec-
tive circuits to prevent sparking and overheating.
Any incorrect or improper use leads to loss of the
warranty. The manufacturer takes no responsibility
for damage(s) arising out of usage that is contrary
to the instructions laid down. The appliance is not
meant for commercial use.
36 GB/MT
W
Watts (Effective power)
V ~
Volt (AC)
Safety class II
Keep children away from
electrical devices!
Check that the device, mains lead
and plug are in good condition!

Delivery Contents

Q
Check the appliance and all accessories for damage
immediately after unpacking. Do not put a defective
appliance or parts into operation.
1 Charger TRONIC T4X SE
2 Quick / contact clamps (1 red, 1 black)
1 Operating manual

Component description

Q
see Fig. A:
LED display (standby)
1
„6 V" LED display „Mode 1"
2
LED display „Mode 2"
3
LED display „Mode 3"
4
LED display „Mode 4"
5
LED display „incorrect polarity / fault"
6
LED display „fully charged"
7
LED display „Charging process active"
8
Q
Selection button „MODE"
9
see Fig. B:
Charging station
10
Mains lead
11
Mounting holes
12
„+"-Pole connection cable (red), incl. ring shoe
13
„–"-Pole connection cable (black), incl. ring shoe
14
„ +"-Pole quick-contact terminal (red), incl. red
15
fixing screw

Publicidad

Tabla de contenido
loading

Tabla de contenido