TRENDnet TPL-310AP Guía De Instalación Rápida página 17

7. After I successfully configured the Access Point to meet my network settings, I cannot connect
to my network using wireless computers.
If you have a DHCP server in your network, you need to go into TCP/IP settings again and re-select
"Obtain an IP address automatically" to allow the PC to regain an IP address from your DHCP server.
8. All the settings are correct, but I cannot make a wireless connection to the Access Point.
1. Double check that the WIFI light on the Access Point is lit.
2. Power cycle the TPL-310AP. Move the power switch to the off position. Wait 15 seconds, and then
move the switch to the on position.
3. Contact the manufacturer of your wireless network adapter. Make sure the wireless network
adapter is configured with the proper SSID. The default SSID of the Access Point is TRENDnet310.
If you have enabled encryption on the Access Point, make sure to configure the wireless network
adapter with the same encryption key.
If you still encounter problems or have any questions regarding the TPL-310AP, please refer to the User's
Guide included on the Utility CD-ROM or contact TRENDnet's Technical Support Department.
15