Introduction; General; Scope Of The Manual - Manostar Compulab 3 Manual De Operación

GENERAL

®
The MANOSTAT VARISTALTIC
control console (catalog number 72-767-000) and up to four pump drives. The pump drives may be any combination of
MANOSTAT COMPULAB RD-1 (catalog number 72-777-100) and RD-2 drives (catalog number 72-666-100). The
control console connects to each of the pump drives with a 3-1/2 ft (1.1 m) RJ-12 cable (catalog number 77095-02).
Each pump drive is identified by the control console with a unique number from 1 to 4, depending on which port on the
console the pump drive is connected.
C o m p u l a
D I S P E N S E R P U M P
®
Division of Barnant Company
CONTROL CONSOLE
The COMPULAB 3 Dispensing System is a microprocessor-controlled, programmable peristaltic pump system designed
to meet liquid-handling needs. The system can be programmed to operate as a dispenser, diluter/dispenser, and an all-
purpose pump. The operator designs programs that contain operational parameters. The programs can be run manually
with the controller, a dispensing wand, or by using the optional footswitch, semiautomatically in cycle, or automatically by
specifying the exact number of cycles to be completed.
The control console can control each pump independently, or pumps can be linked and controlled simultaneously.
Operation can be varied to suit specific applications by dispensing cumulative volume, flow in mL/min, and/or by cycle
count. The dispenser can communicate with a variety of balances in order to dispense liquid by weight. A built-in RS-232
interface allows the dispenser to be controlled by a personal computer.

SCOPE OF THE MANUAL

This manual contains instructions for installing, setting up, programming, operating, and maintaining the dispensing
system. It is intended for use by technicians and operators as well as maintenance personnel. TROUBLESHOOTING
contains a list of possible problems, their probable causes, and actions to take to remedy each problem.
Instructions for replacing user-serviceable parts and a list of parts that can be ordered are included. ACCESSORIES
lists all available accessories for the COMPULAB 3. SPECIFICATIONS lists pertinent characteristics of the
COMPULAB 3. APPENDIX A — BALANCE CONNECTION provides pinout and signal information for connecting a
balance to the dispenser. APPENDIX B — PC CONNECTION AND SOFTWARE INSTALLATION provides details to
connect the COMPULAB 3 to a personal computer.
®
COMPULAB
C o m p u l a b
I
O
C o m p u l a b
®
b 3
D I L U T E R
PUMP
SPEED
BACK ENTER
VOLUME
#
S T O P
P U M P
A L L
Figure 1. COMPULAB 3 Modular Dispensing System

INTRODUCTION

®
3 Modular Dispensing System, as shown in Figure 1, consists of a
PUMP #4
®
3
®
Division of Barnant Company
PUMP #2
®
3
I
O
®
Division of Barnant Company
1
PUMP #3
®
C o m p u l a b 3
I
O
®
Division of Barnant Company
PUMP #1
®
C o m p u l a b 3
I
O
®
Division of Barnant Company