Dynamic Range Control); Digital Audio Setup - Coby DVD968 Manual De Instrucciones

System Setup
If the speaker is set to LARGE, the output level will be higher than
that of SMALL.
If the speaker is set to SMALL, the output level will be lower than
that of LARGE.
If a speaker is set to OFF, no audio is output from it.
DIALOG
When DOWNMIX mode is set to LT/RT or STEREO, this item is available.
Adjust the value of this item to control the dialog volume (e.g., spoken
audio).
NOTE: When playing a disc encoded with 5.1 channels, this item can be
used to adjust the volume of the speakers.
D.R.C. (Dynamic Range Control)
You can set this item to AUTO, ON or OFF.

Digital Audio Setup

Digital Output
Set this option to SPDIF/RAW or SPDIF/PCM to activate the coaxial digital
audio output connection.
SPDIF/OFF: There will be no digital audio signal output. (Coaxial off)

SPDIF/RAW: The digital audio signal output will be in its raw format.

This mode is usually used for DTS & Dolby Digital 5.1 signals.
SPDIF/PCM: The digital audio signal output will be in PCM format.

This mode is usually used for audio CD signals.
Page 38 Coby Electronics Corporation