Publicidad
Idiomas disponibles
Idiomas disponibles
M3. Switching Wave mode: Two pumps are needed to be operated at the same time, P1 work, P2
stop;P2 work, P1 stop;P1 work, P2 stop. cycles like this. Cycle period (Frequency) can by adjusted
by pressing the "Fre/T/<>"button and adjust the flow rate by pressing "SPEED/LIGHT".
M4. Sine Mode: One or more pumps can operate at the same time in this mode. The power various
between 30%-100% and the regulation looks like a sine curve.
M5. Random Mode: One or more pumps can operate at the same time. It is a random mode as the
power of pump is changing at a random data all the time without regulation.
M6. Switching flow mode: Two pumps are needed to be operated at the same time, P1 work, P2
stop;P2 work, P1 stop;P1 work, P2 stop. cycles like this. Cycle period (1min-99min) can by adjusted
by pressing the"Fre/T/<>"button and adjust the flow rate by pressing "SPEED/LIGHT".
WARNING
• The Controller and adaptor is IPX0 ,must not be contacted with water.
• Carefully examine the application after installation. It should not be
plugged in if there is water on parts not intended to be wet.
• Don't operate any appliance if it has a damaged cord or plug. The power
cord can not be replaced .
• Closed supervision is necessary when the appliance is used by or near
Children.
• Always unplug it from outlet when not in use ,before putting on or taking
off parts and before cleaning.
Maintenance
Regularly cleaning is required to ensure effective action.
1. Please regularly clean the pump to ensure it function properly.
2. Please clean water on the cover of controlling panel with dry cloth to avoid water entering into the
inside of the panel.
3. Take off the holder and remove the front cover of pump (Clockwise: close; Counter-clockwise:
open). Ref to fig.1 .Clean the pump and component by dry soft cloth. Please take care all the
component and assemble it in right way after cleaning, ensure the ceramic shaft to be located in
the Silicone cap on the front cover .
4. The product is used in door. The controlling panel and adapter should not be in contact of water.
Publicidad
