Product Safety - Worx WG584E Manual Del Usuario

PRODUCT SAFETY

WARNING Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
The appliance is only to be used with
the power supply unit provided with the
appliance.
IMPORTANT
READ CAREFULLY BEFORE
USE.
KEEP FOR FUTURE
REFERENCE.
Safe operating practices
1) TRAINING
a) Read the instructions carefully. Be familiar
with the controls and the correct use of the
machine.
b) Never allow children, persons with
6
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge or people unfamiliar with these
instructions to use the machine, local
regulations may restrict the age of the
operator.
c) Never operate the machine while people,
especially children, or pets are nearby.
d) Keep in mind that the operator or user
is responsible for accidents or hazards
occurring to other people or their property.
2) PREPARATION
a) While operating the machine, always wear
substantial footwear and long trousers. Do
not operate the machine when barefoot
or wearing open sandals. Avoid wearing
clothing that is loose fitting or that has
hanging cords or ties.
b) Do not wear loose clothing or jewellery
that can be drawn into the air inlet. Keep
long hair away from the air inlets.
c) Obtain ear protection and safety glasses.
Wear them at all times while operating the
Cordless Li-Ion Blower/Sweeper
machine.
d) Operate the machine in a recommended
position and only on a firm, level surface.
e) Do not operate the machine on a paved
or gravel surface where ejected material
could cause injury.
f) Before using, always visually inspect to
see, that the fasteners are secure, the
housing is undamaged and that guards
and screens are in place. Replace worn or
damaged components in sets to preserve
balance. Replace damaged or unreadable
labels.
3) OPERATION
a) Before starting the machine, make certain
that the feeding chamber is empty.
b) Keep your face and body away from the
feed intake opening.
c) Do not allow hands or any other part of
the body or clothing inside the feeding
chamber, discharge chute, or near any
moving part.
d) Keep proper balance and footing at all
times. Do not overreach. Never stand at a
higher level than the base of the machine
when feeding material into it.
e) Always stand clear of the discharge zone
when operating this machine.
f) If the machine should start making any
unusual noise or vibration, immediately
shut off the power source and allow the
machine to stop. Remove the battery pack
from the machine and take the following
steps before restarting and operating the
machine:
i) inspect for damage;
ii) replace or repair any damaged parts;
iii) check for and tighten any loose parts.
g) Do not allow processed material to build
up in the discharge zone; this may prevent
proper discharge and can result in kickback
of material through the intake opening.
h) If the machine becomes clogged, shut-off
the power source and remove the battery
pack from the machine before cleaning
debris.
i) Never operate the machine with defective
guards or shields, or without safety
devices.
EN