Specifications - M-Audio Octane Manual De Instrucciones

Specifications

Analog Features:
20dB input pads
8 balanced microphone inputs with:
50dB continuously variable gain
Phantom power (48V) with indicator for channels 1 through 4
Phantom power (48V) with indicator for channels 5 through 8
System throughput gain (balanced in / balanced out): 19dB to 70dB (-1dB to 50dB with 20dB pad engaged)
Frequency Response: 20Hz-20kHz, +/- 0.11 dB; mid gain
Signal-to-Noise Ratio: 120dB, A-weighted; mid gain
Dynamic Range: 120dB, A-weighted; mid gain
THD+N: 0.00041% @ -107dB, 1dB below clipping, 22Hz-22kHz; mid gain
EIA noise rating: -129dBu @ max gain, 600 ohms, 22Hz-22kHz
Input impedance: 2850 ohms with pad dis-engaged; 3600 ohms with pad engaged
Input Impedance: 3M Ohms
2 unbalanced instrument inputs with:
Continuously variable gain: 44dB
Instrument inputs automatically engage when plugged in
System throughput gain: 6dB to 50dB (balanced out); 0dB to 44dB (unbalanced out)
Frequency Response: 20Hz-20kHz, +/- 0.03 dB; mid gain
Signal-to-Noise Ratio: 133dB, A-weighted; mid gain
Dynamic Range: 133dB, A-weighted; mid gain
THD+N: 0.0018% @ -95dB, 1dB below clipping, 22Hz-22kHz; mid gain
Ch. 7 & 8 inputs are M & S respectively
MS matrix (enabled; width set mid position):
Ch. 7 & 8 outputs are L & R respectively
Matrix: L=M+S/3 and R=M_S/3
Maximum rated analog output (digital clip): Balanced: +26dBu; Unbalanced: +20dBu
Additional analog:
Rear Line Input impedance: 20K Ohms balanced, 13.3K Ohms unbalanced
Output impedance: 600 Ohms balanced
Channel 1 bass cut switch: -12dB/octave below 80Hz
Phase inverter switch on channels 2, 4, 6 & 8
Digital Features:
Output: Lightpipe; 8 channel, 24-bit, ADAT optical format
8 balanced/unbalanced direct A/D analog inputs:
Frequency Response: 20Hz-20kHz, +/- 0.04dB
Signal-to-Noise Ratio: 110dB, A-weighted
Dynamic Range: 110dB, A-weighted
THD+N: 0.00067% @ -103dB, -1dBFS, 22Hz-22kHz
Digital clip level at direct inputs: +20dBu
Channel quasi-peak level indicators light 3dB, 10dB & 20dB below digital clip.
Supported sample rates (manually switched): 44.1kHz, 48kHz & external (word clock)
Word clock Input and Output with lock indicator, lock range: 33kHz to 59kHz
18 VAC (16.5 VAC minimum) @ 3.5A inline power supply
Power Requirements:
9