Operation Instructions; Service - DRESTER Boxer double Solvent DB21S Manual De Operación

Place the second drum, now half full, on the fl oor on the
right-hand side of the fi rst drum (item 3 illustration 2). Insert
the second group of hoses containing the 6mm hose into this
drum (item 5 illustration 2). Make sure that the hose is properly
led into the drum all the way down to the bottom, and that the
opening is well sealed by the tapered plug.
The solvent system is now fi lled-up. Both drums should be half
full. The left-hand drum, contains the solvent that will be recir-
culating for the automatic wash cycle, and the right-hand drum
contains clean solvent for rinsing. The contents of the right
drum will gradually be used up and transferred to the left drum.
Operating instructions
Operating instructions should be formulated on the basis of
this manual and translated into the language spoken by the
employees. It should always be available close to the machine.
To avoid confusion, the employees must be informed about the
solvent currently being used in the machine.
OPERATING INSTRUCTIONS
Empty the spray-gun of any residual paint into a separate spills-
dish.
Open the main valve for compressed air (item 7 illustration 1).
Open the lid for the automatic washer (make sure it `clicks` into
the full open position).
Place the spray-gun inside (see illustration 5).
Be sure to fi t the trigger clip following illustration 6, and to
push the spray-gun up against the nozzle for the paint-channel
(item 1 illustration 5) before you lock it into position with aid of
the magnets of the trigger clip.
If you prior to cleaning prefer to remove the Air-cap and the
needle of the spray-gun, then place those items as shown by
arrow 5 in illustration 5.
Close the lid, and start the automatic pre-wash cycle by press-
ing the foot pedal No.8 in illustration 1. The spray-gun will now
be automatically cleaned for approx. 1.5 minutes with circulat-
ing solvent.
When the automatic pre-wash cycle is completed, the lid can
be opened and the spray-gun taken out. It can now be manu-
ally further washed or rinsed if required.
By pressing foot pedal No.10 in illustration 1 (NOTE: press it all
the way down !), recirculating solvent will be fed through the
brush placed in the sink (item 1 illustration 7).
By pressing foot pedal No.11 in illustration 1, clean solvent
will be fed through the spray-nozzle placed in the sink (item 2
illustration 7).
The brush and spray-nozzle in the sink can be used indepen-
16018 rev 2014-11-06
dently of the automatic washer at any time, provided that the
lid for the automatic washer is closed. The intensity of the spray
can be adjusted with the air-fl ow restrictor (item 1 illustration
14).
Connect the spray-gun to the air-line on the left side of the
machine (item 4 illustration 1), and blow out the spray-gun
through the funnel in the sink (item 3 illustration 7). By using
this funnel, you prevent the fumes from spreading within the
premises.
Finally, the spray-gun can be blown dry by using the air-gun on
the right side of the unit (item 12 illustration 1).
Close the lid after cleaning.

SERVICE

Weekly:
– Remove the strainer at the bottom of the automatic washer
(item 2 illustration 5) and clean it,
it!
Monthly:
– Remove the fi ve nozzles automatic washer and clean them
with clean solvent. (see illustration 8).
When changing drums:
– Check and if necessary clean the strainer on the suction
hose for circulating solvent.
do not forget to re-fi t
5