Setting The Wind Speed Unit; Setting The Wind Alarm; Setting The Wind Chill Alarm - OWIM H13726 Instrucciones De Utilización Y De Seguridad

... / Setting the wind ... / Setting the Wind Alarm / Setting the Wind Chill Alarm
the current air pressure value, e.g. from the newspaper
or Internet.
Hold the PRESSURE button down for approx. 3 seconds
until you hear a confirmation tone. The air pressure
value now flashes on the display. Use ▲ or ▼ to set
the desired value. Press the PRESSURE button to return
to the standard display. The standard display will
also appear automatically if no setting button is
pressed for approx. 1 minute.

16. Setting the wind speed unit

The wind speed can be displayed in 5 different units.
– km / h (kilometres per hour)
– mph (miles per hour)
– m / s (meters per second)
– knots
– Beaufort
Press the WIND UNIT button on the rear side of the
weather station to switch between the different units.

17. Setting the wind alarm

A wind alarm can be set for gusts (maximum speed
for the last 10 minutes). Press the WIND ALARM
button until ALARM and GUST appears on the display.
Hold the WIND ALARM button down for approx.
3 seconds until a confirmation tone sounds and the
value flashes.
Use ▲ or ▼ to set the desired value. Press the
WIND ALARM button to confirm the entry and
appears on left next to the wind speed.
The wind alarm is now activated. Press WIND AL
to deactivate the wind alarm again. Press WIND AL
until disappears.
If a gust of wind reaches or exceeds the set value,
a warning signal sounds for approx. 1 minute and
flashes in the display.
Press WIND ALARM to stop the alarm tone prema-
turely. flashes until the gusts of wind (over the
last 10 minutes) fall below the set limit value again.

18. Setting the wind chill alarm

A Wind Chill Alarm can also be set. Press the
WIND ALARM button until ALARM appears next
to the Wind Chill temperature.
GB/MT 77