Care And Maintenance - Roberts 10-2000GT Manual De Operación

INTRODUCTION
The 10-2000GT XL Knee Kicker incorporates a number of new concepts and features to improve reliability
and performance.
This is the first knee kicker to use computerized stress analysis to design components that withstand the forces
required to stretch today's tougher carpet backings.
A major advance in bumper pad construction reduces shock to the knee. The new bumper was laboratory tested
in a major Technical University to measure knee impact shock and energy transfer to the head pins. The bumper
pad has been submitted to the U.S. Patent Office, and has a "Patent Pending" status. This bumper pad can be
used on all Roberts kickers.
The GT2000 head is 28% wider than standard knee kickers, to provide a better grip and reduce stress
concentration on carpeting material. Instead of the usual three nap strips, there are now four! The GT2000
channel has a 12% greater cross section than traditional kickers for added strength, and thicker channel stops
maintain precise opening range and eliminate wear.
Components for the knee kicker are precision die-cast aluminum alloy, with extra thick walls.
LENGTH ADJUSTMENT
The GT2000 XL Knee Kicker adjusts from 18" to 22" in length to suit the user's preference and job requirements.
To adjust the kicker, depress the steel trigger on the bottom of the body casting, and pull the bumper/channel
assembly to the desired setting.
M M A A K K E E S S U U R R E E T T H H E E T T R R I I G G G G E E R R I I S S F F U U L L L L Y Y S S E E A A T T E E D D I I N N T T H H E E C C L L O O S S E E D D " " S S T T O O P P " " P P O O S S I I T T I I O O N N ! ! M M A A K K E E S S U U R R E E T T H H E E R R E E A A R R P P A A R R T T
O O F F T T H H E E T T R R I I G G G G E E R R I I S S F F L L U U S S H H W W I I T T H H T T H H E E B B O O D D Y Y C C A A S S T T I I N N G G . . Test the security by pulling back and forth on the bumper.
VERTICAL ADJUSTMENT OF PIN PLATE
The pin plate containing the large hardened steel pins can be adjusted by rotating the adjustment knob on the
kicker head. The knob has twelve positions, and the pins can be extended to 1/2" below the head casting. Use
the proper pin length suited to the carpet weight you are installing. For lighter carpeting, the nap strips are
generally sufficient to engage the material, and the pin plate can be retracted to the full "up" position. Extend
the pins for heavy carpets with firm backing.
BUMPER
The new patent pending bumper is designed to reduce shock and injury to the knee. It has a progressively dense
material to gradually absorb shock.
The bumper should be rotated occasionally to distribute wear by removing the four Phillips head screws, and
rotating the bumper 90 degrees.
Do not continue to use a worn or damaged bumper, as injury or discomfort could occur. Order a replacement
bumper part number 10-2000-09 from your Distributor.
Note that all Roberts bumpers are interchangeable on all Roberts kickers.

CARE AND MAINTENANCE

1. Remove lint and carpet pile from the nap strips with a small screwdriver blade from time to time to maintain
the gripping strength of the nap strips.
2. Apply light, white grease to the channel occasionally to keep it lubricated. REMOVE EXCESS GREASE with a
clean cloth.
3. The polished aluminum finish will oxidize and become dull after a period of time. Use an aluminum polishing
compound to restore the original shiny surface. Be sure to remove all polish after you finish. Wrapping your
kicker in a towel when not in use will help preserve the finish and prevent damage.