Features; Accessories; Front - Dynex DX-LTDVD20 Guia Del Usuario

4
Outdoor antenna grounding
If an outside antenna or cable system is connected to your TV combo,
make sure that the antenna or cable system is grounded to provide some
protection against voltage surges and built-up static charges. Article 810
of the National Electrical Code, ANSI/NFPA No. 70, provides information
with respect to correct grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge unit, size of
grounding conductors, location of the antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding
electrode.
An outside antenna system should not be located near overhead power
lines or other electric light or power circuits, or where it can fall into such
power lines or circuits. When installing an outside antenna system,
extreme care should be taken to keep from touching such power lines or
circuits, because contact with them can be fatal.
1
1 Electric service equipment
2 Power service grounding electrode
system
3 Ground clamps
4 Grounding conductors
5 Antenna discharge unit
6 Grounding clamp
7 Antenna lead-in wire
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to
Article 820-40 of the NEC that provides guidelines for correct grounding
and in particular, specifies that the cable ground must be connected to
the grounding system of the building as close to the point of cable entry
as practical.

Features

Accessories

Make sure that the following accessories are provided in the packaging:
• YPbPr cable
• Power cord
• Remote control and batteries

Front

7
6
5
4
3
2
No.
1
2
3
4
5
6
7
8
9
10
11
12
8 9
1
OPEN/
CLOSE
2
PLA Y
3
ST OP
4
DISC IN
5
NEXT
6
PREV
7
Component
OPEN/CLOSE
PLAY
STOP
Disc IN indicator
NEXT
PREV
Disc slot
Power/Standby indicator Lights when your
IR sensor
CH+/CH–
Volume+/Volume–
MENU
Features
CH
10
CH
VOL
11
VOL
12
MENU
13
INPUT
14
POWER
PHONES
INPUT 2
VIDEO
L
AUDIO
R
Description
Press to eject the disc in
the disc slot.
Press to change to DVD
mode and begin disc
playback.
Press to stop disc
playback.
When Iit, indicates a DVD
or CD is loaded into the
disc slot.
Press to skip to the next
chapter or track.
Press to skip to the
previous chapter or track.
Insert a DVD or CD to
change to DVD mode and
play the disc.
TV combo is plugged into
a power outlet. When
your TV combo is on, the
indicator is green. When
your TV combo is in
standby mode, the
indicator is red.
Receives signals from the
remote control. Do not
block.
Press to change the
channel.
Press to adjust the
volume.
Press to open the TV
menu.