Default Settings - Urmet Sinthesi Steel Manual De Instrucciones

Módulo de apertura de la puerta con teclado 2 relés
Ocultar thumbs Ver también para Sinthesi Steel:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

DELETING A CODE
Access programming mode.
Enter confi guration code 99 nn where:
99 identifi es the function code to be deleted
nn defi nes the code memory location; possible
values from 01 to 22.
Press
to confi rm.
The device will beep three times and the red LED
will blink three times.
If the entered code is wrong, the device will beep
twice in rapid succession and wait for the correct
code to be entered.
CODE CHANGE PASSWORD
PROGRAMMING PROCEDURE
The code edit password may only be used to edit the
activation codes without accessing programming
mode.
Access programming mode
Enter confi guration code 36 xxxxxxxx where:
36
identifi es the password change function
code
xxxxxxxx defi nes
the
will replace the one used to access
programming mode.
Press
to confi rm.
The device will beep three times and the red LED
will blink three times.
If the entered code is wrong, the device will beep
twice in rapid succession and wait for the correct
code to be entered.
CHANGING A STORED CODE
Press
, X,
Enter the code changing password
Press
to confi rm.
The device will beep three times and the red LED
will light up for confi rmation.
Enter confi guration code 90 oooo where:
90
identifi es the code change function
code
ooooo
is the old activation code
Press
to confi rm.
Enter the new activation code (from 3 to 8 digits).
Press
to confi rm.
The device will beep three times and the red LED
will blink three times.
If the entered code is wrong, the device will beep
twice in rapid succession and wait for the correct
code to be entered.
6
new
password
.
TIMESLOT TERMINAL
PROGRAMMING PROCEDURE
By enabling the timeslot function, a timer (not
included) may be used to program the periods
of the day when to activate the relays simply by
pressing
Access programming mode.
Enter confi guration code 40 a where:
40 identifi es the programming function code
a
defi nes the number of relays enabled during
the timeslots.
1 = relay 1
2 = relay 2
0 = function off
Press
The device will beep three times and the red LED
will blink three times.
If the entered code is wrong, the device will beep
twice in rapid succession and wait for the correct
code to be entered.
which
ACTIVATION CODE +
PASSWORD RESET
PROCEDURE
Disconnect power from the device.
Hold the programming switch next to the terminal
board pressed.
Power the device while the switch is pressed.
A long beep will be heard.
Release the switch after ~5 seconds.
The device will beep three times for confi rmation
when the switch is released.
All the previously programmed codes, times and
passwords will be deleted.

DEFAULT SETTINGS

Relay 1
Function
Activation time
Button confi rmation
Relay 2
Function
Activation time
Button confi rmation
Timeslot terminal
.
to confi rm.
Monostable
200 ms
No
Monostable
200 ms
No
OFF
DS1148-003B

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sinthesi1158/461148/46

Tabla de contenido