First Use; Cleaning / Maintenance; Maintenance; Cleaning - Targa LSL 10 A4 Manual De Instrucciones E Indicaciones De Seguridad

 Run the power cable [6] through the cable gland [5].
 Connect the power cable [6] using the screw terminal [7]. Make sure that
the individual wires of the power cable [6] are connected correctly.
Wire
Black or brown
Blue
Yellow/green
 Then screw the power cable [6] with the rubber seal tightly in the cable
gland [5].
 Close the junction box [2] by screwing the cover again tightly with the
four screws that you previously removed. When closing the junction box
[2], ensure that the sealing ring lies correctly in the groove. Otherwise, IP
protection is not guaranteed.
 Then attach the LED spotlight to the mounting bracket [4]. To do so, use
the previously removed screws [3], spring and flat washers. Make sure
that the flat washers are located between the LED spotlight [1] and the
mounting bracket [4]. The spring washers must be between the screw
head and the mounting bracket [4].

7. First use

After you have installed the LED spotlight as previously described, you can
connect the circuit again. You can now switch the LED spotlight on and off
via the corresponding light switch of your home lighting system.

8. Cleaning / maintenance

8.1. Maintenance

The light bulb of the LED spotlight is a long-lasting LED. It cannot be
replaced and does not require maintenance.
The light source of this light cannot be replaced; when the light source has
reached the end of its service life, the entire light must be replaced.

8.2. Cleaning

Ensure that no liquid can penetrate the
housing. There is a risk of an electric shock.
To clean the LED spotlight, use a soft, dry cloth and never use any solvent or
cleaner that would corrode the plastic materials. Use a slightly damp cloth
for more stubborn dirt.
Symbol
L
N
LIVARNO LUX LSL 10 A4
Designation
Phase
Neutral
Earth conductor
English - 17