IMPORTANT, FAILURE TO CAREFULLY READ, UNDERSTAND AND FOLLOW EVERY PART OF THIS
DOCUMENT MAY RESULT IN PROPERTY DAMAGE, SERIOUS BODILY INJURY OR DEATH
1. Check that the control knob for the gas
supply system is turned to the "OFF"
position before starting any assembly.
2. Remove the burner cover(F) from body(C).
Note: Cover must be removed when burner is in operation.
3. Remove door(E) from body(C) and place the
propane gas tank (not included) into the tank holder.
Tighten the preassembled wing screw clockwise to
ensure the propane tank is secure. Replace the
door(E) after the tank is connected to the regulator
(see below).
P655-901
INSTALLATION
Page 9 of 43