Kenmore 580.76100 Manual Del Propietário página 4

OBSERVE ALL LOCAL CODES AND
ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUND PRONG.
ELECTRICAL GROUND IS REQUIRED ON
THiS APPLIANCE.
A 250=volt 60 Hz, AC only, 20A fused and
properly grounded electrical supply is required.
A time delay fuse or time delay circuit breaker
is recommended. Use a dedicated circuit,
serving only this appliance.
DO NOT USE AN EXTENSION CORD.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance must
be grounded. This appliance has a power
supply cord with a 3=prong grounding plug. To
minimize possible shock hazard, the cord must
be plugged into a mating grounding type wall
receptacle and grounded in accordance with
the National Electrical Code (ANSl/NFPA 70)
latest edition and all local codes and
ordinances. If a mating wall receptacle is not
available, it is the personal responsibility and
obligation of the customer to have a properly
grounded 3=prong wall receptacle installed by a
qualified electrician.
115V- 230V~
NOTE: The shape may be different according to its model.
Power cord may include a current interrupter
device. A test and reset button is provided on the
plug case. The device should be tested on a
periodic basis by first pressing the TEST button
and then the RESET button. If the TEST button
does not trip or if the RESET button will not stay
engaged, discontinue use of the air conditioner and
contact a qualified service technician.
Use Wall Receptacle Power Supply
_ Standard 125V,
3-wire grounding
receptacle rated
15A, 125V AC
(_ tandard 250V,
3-wire grounding
receptacle rated
15A, 250V AC
(_ tandard 250V,
3-wire grounding
receptacle rated
20A, 250V AC
Use 15 AMP. time
demay fuse or 15 AMP.
circuit breaker.
Use 20 AMP. time
delay fuse or 20 AMP.
circuit breaker.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death fire or electrical shock
You can choose between two methods below according to your window stool shape and preference.
USING SLiT "A"
Fasten the stopper using 1 screw holes, and lead
out the power cord through slit "A".
USING SLiT "B"
Fasten the stopper using left screw hole, and rotate
properly to lead the 3ower cord out through slit "B".
_.,
=4=