Care And Cleaning - ProctorSilex 60200 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating the Mixer
w WARNING
Cut Hazard.
• Disconnect power before installing or removing
any parts.
• Failure to do so can result in serious injury or cuts.
Removing/Installing the Container Guide and
Container Guide Pin
The container guide and container guide pin are
removable for easy cleaning.
To remove the container guide and container guide
pin:
1. Unplug mixer.
2. Hold the container guide by the indents on each
side and pull it straight out.

Care and Cleaning

Cleaning the Container, Spindle, and Agitator
1. Place a drop of detergent and 1 cup of water into
the mixing container.
2. Position the container into the container guide
and mix on low speed (I) for 5 seconds. Empty the
container.
3. Place 1 cup of clean water into the container and
repeat mix for 5 seconds to rinse.
w WARNING
Electrical Shock Hazard.
• Disconnect power before cleaning.
• Failure to do so can result in death or electrical
shock.
4
3. To remove the plastic container guide pin, press the
retainer clip and slide it up; then rock it back down
and out of the container guide.
4. Reverse steps 1–3 to reinstall the container guide and
container guide pin, being sure to note the proper
orientation.
Sanitizing the Container, Spindle, and Agitator
For best results, use the replacement container (#110E).
1. Fill the container with sanitizing solution (1 Tablespoon
of household bleach per 1 gallon of water at 50°–70°F)
to 3/4 full. Position the container properly on mixer
and run on low speed (I) for 1 minute.
2. Remove container. Empty sanitizing solution and
rinse container.
3. To dry, run the mixer on low speed (I) for 30 seconds
with empty container in place. DO NOT RINSE after
sanitizing is completed.
NOTE: If preferred, the container guide and container
may be cleaned in a dishwasher.
Cleaning the Container Guide, Container Rest,
and Housing
1. Unplug mixer.
2. Remove the container guide.
3. Wash the container guide with hot, soapy water;
then rinse.
4. Clean the housing, front panel, and container rest
with a damp, soapy cloth.
5. Wipe dry with a clean, soft cloth.
6. Reinstall the container guide.
NOTE: Do not spray or submerge the mixer. Any
resulting water damage will not be covered by the
warranty.
7. Plug mixer into a grounded outlet.
Press

Publicidad

Tabla de contenido
loading

Tabla de contenido