Note on material damage
The shower radio is protected from moisture, but
neither it nor the supplied cables should be immersed
in water or other liquids. Protect the device from
excessive moisture, direct sunlight and dirt.
Before using in the wet area, make sure that the
rubber tab is present and securely covers the
connection sockets located underneath.
Do not connect the radio to a speaker output of a
separate power ampli er. This would damage the
radio.
Condensation can build up inside the radio if you
move it from a very cold place to a very warm place.
Wait a few hours before turning on the radio.
Keep magnetic stripe ID cards, credit cards, etc. away
from the device. The built-in magnets inside the radio
could damage them.
Never use harsh, scouring or abrasive cleaning agents
or the like to clean the radio. Doing so may scratch the
surfaces.
Pull the protective film off the display.
Shower radio BR 1703-1 | 1703-2
29