Care And Maintenance - Seac GURU HP User Manual

Care and maintenance

• Keep your Transmitter clean and dry. Do not expose it to
chemical agents, including alcohol.
Use only fresh water to clean your Transmitter,
removing all saline deposits.
m WARNING!
Only wash the Transmitter when it is connected to the
first stage. Do NOT wash the Transmitter if the hole that
connects with the first stage is not properly protected from
the water.
When disassembled from the first stage, affix the
protective cap on the Transmitter threads. To dry the
Transmitter, leave it naturally in the shade. Do not use jets
of cold or hot air.
• Do not expose the Transmitter directly to the sun or sources
of heat higher than 50°C. Store it in a cool (5°C-25°C), dry
place, making sure to put the protective cap on the threads.
• Do not attempt to open, modify, or repair the Transmitter
yourself. Always contact SEAC.
• The warranty will be forfeited if the computer or the
Transmitter are opened by an unauthorized service center.
• Do not place the computer or the Transmitter in a hyperbaric
chamber.
• The GURU computer and the Transmitter are built to
withstand use in sea water, but after the dive they must be
rinsed thoroughly in fresh water and not exposed directly to
sunlight or sources of heat to dry them.
• Check that there are no traces of humidity on the inside of
the device.
6 English
m WARNING!
Do not attempt to open the device for any reason.
If you have problems, contact an authorized SEAC center,
or contact SEAC directly. Breaking the seals on the device
immediately and irreversibly voids all warranties on the
product.