Pairing A Bluetooth Device - Denon Professional Envoi Guia Del Usuario

Operation
Wireless Mic Setup
To use the included wireless mic, follow these setup steps:
1. Ensure 2 new AA alkaline batteries are installed in the wireless mic (see the battery
installation side graphic). The microphone handle unscrews to reveal the battery
compartment. Screw the handle back on with the threads facing inward.
2. On the UHF Receiver panel on Envoi, turn on Power-Vol knob clockwise.
3. Turn on the wireless microphone using the switch found on the bottom of the
microphone. Watch the AF indicator to make sure a signal is being received.
4. Use the Up or Down buttons to select a wireless channel that gives a strong signal.
5. Hold the microphone close to your mouth when speaking and the AF LED will
illuminate on the Wireless Mic Settings panel. Adjust the Power-Volume knob to
increase the level.
Note: If needed, the High/Low (H/L) switch on the wireless mic (see the side
graphic) can be adjusted to increase the signal range. The High power setting
consumes more battery power to provide extended range and reception. The Low
setting extends battery life for use in scenarios where a lower operating range is
acceptable.
Note: If needed, the gain adjustment on the microphone can be adjusted clockwise
for more output gain. For less output gain, the screw can be adjusted counter-
clockwise.
Mute Level
In most situations this should be left at the factory preset position. However, in cases of
high RF activity, the mute levels can be re-adjusted to suppress interference from other
wireless devices in a shared RF environment. This will reduce interference when an audio
signal is not present. If the AF or RF LEDs flicker or stay on when the wireless
microphone is off, the Mute Level screw on the UHF receiver panel should be turned
counter-clockwise until the LEDs are off. When the Mute Level is properly adjusted, the
corresponding AF and RF LEDs will light up only when the wireless microphone is being
used.
Setting ASC (Auto-Sync Channel)
If you receive interference or if another channel is needed, select another channel using
the ASC (Auto-Sync Channel) button.
1. Select the UHF channel you want to use with the best reception using the Up or
Down buttons.
2. Turn the microphone on and place the microphone's sensor (found above the
battery compartment, seen in the graphic above) near Envoi's IR LED.
3. Press the ASC button once on Envoi and wait for about 3 seconds, until the IR
LED stops flashing. When it finds an interference-free channel, the wireless mic will
be matched to that channel.

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Envoi.
3. Navigate to your Bluetooth device's setup screen, select Bluetooth which is the Envoi speaker, and connect.
Note: If prompted for a passcode, enter 0000.
4. Play music from your Bluetooth device.
5. Adjust the volume from Envoi by holding down the |<< or >>| button to decrease or increase the volume.
6. To disconnect pairing, turn off Bluetooth on your device or select "Delete paired info" from the Envoi
Bluetooth menu.
7