PowerStation PSX3 Manual Del Propietário página 12

USE OF THE PSX3
RISK OF FIRE, EXPLOSION OR BURNS
Before connecting the jumpstarter cables, check the ON/
OFF switch to confirm that it is in the OFF position. The
reverse polarity warning function does not protect the
PSX3 or your vehicle from damage if the cables are not
correctly connected and the ON/OFF switch is in the ON
position. If the red "cables reversed" LED illuminates
CAUTION
and the warning buzzer sounds when the cables are
attached to the vehicle battery, STOP! Make certain the
Red positive clamp on the jump start is connected to the
Positive battery terminal in the vehicle and the Black
negative clamp is grounded to the vehicle.
Never allow the jumpstarter's red and black cable clamps to
touch each other or a common metal conductor. Such contact
could cause sparking, an explosion and/or damage to the unit.
WARNING
Connect red clamp to the positive (+) battery terminal.
The black clamp should be attached to the engine block or other
non-moving metal part of stalled vehicle. Do not connect black
clamp to the negative (-) battery terminal. Doing so could cause
WARNING
damage to the unit and/or create a sparking/explosion hazard.
Do not try to jumpstart a battery for more than six seconds.
Allow the unit to cool for three minutes after each six second
jumpstart.
WARNING
The jumpstarting cable connection has enough energy to cause
a spark, create an explosion hazard, or cause burns if a metal
object contacts both terminals. Keep the jumpstarter switch in
the OFF position, except when executing the jump start
WARNING
procedure. Do not turn on the jumpstarting function without
having cables securely attached.
031413
continued
PSX3 Owners Manual Page 10
.
(continued)