Intelligent Facility Solutions GFM201 Manual De Instalación Y Utilizacion página 15

PREVENTIVE MAINTENANCE AND CLEANING
Adequate cleaning of the hand dryer will extend its useful life. It is recommended to remove any
dust accumulated inside the hand dryer at least once a year.
To clean the hand dryer correctly, take the following steps:

Disconnect the hand dryer from the power supply.

Remove the two lower screws that fix the casing to the base using the special spanner
provided.

Remove the casing as instructed in the chapter "Removing the casing" and place it on a
cloth, to prevent scratching or rubbing at all times.

Clean away the dust and remove any dirt accumulated inside the hand dryer, using a
dry cloth or a soft brush.

Clean from the air input to inside the motor (upper part of the nozzle) preventing dust or
dirt falling inside the turbine-motor assembly.

Carefully clean the dust away from around the electronic circuit located inside its box-
type housing. Carry out this operation taking maximum care not to damage any
component of the electronic circuit.

Use a soft cloth to clean the surface of the IR sensor protector screen.

Clean the casing using a damp cloth moistened in a solution of neutral soap and water.
After cleaning the entire surface rinse the soap from the casing using another cloth
moistened in water and dry using a dry cloth.

Close the hand dryer by assembling the casing once more, tightening the screws that
fix the casing to the base and connect to the power grid.

Start the hand dryer up 2 or 3 times in a row to ensure that all remaining dust is
extracted.
CLEANING OF CHROMED AND GOLD PLATED COVERS
For cleaning purposes only a wet cloth is to be used. Do not use any kind of
detergent, acids, lye, abrasives, hydrochloric acid, etc.
Take care not to damage or force any component.
15