Connecting The Remote Turn-On; Wiring And Connecting The Inputs; Connecting High-Level Inputs - Insignia NS-A1000 Guia Del Usuario

Connecting the remote turn-on

The remote turn-on is typically wired to the power antenna output of
your car stereo. With this connection, the amplifier is turned on
automatically when the vehicle's stereo is turned on.
Note

Wiring and connecting the inputs

Wire routing is critical for noise-free performance. For satisfactory
input wiring, observe the following:
• Always use high-quality RCA-type shielded cables.
• Always use the shortest length possible. If the cable is too
long, make an S-type loop (not a coiled loop) in the center of
the cable to take up any excess.
• Never cut or splice the shielded cable.
• Never route any amplifier input cables near to, or parallel with,
speaker outputs, high-energy ignition wires, or
computer-controlled ignition circuit units (computer units may
be found behind or under the dash panel in late model cars).

Connecting high-level inputs

Caution
Note
8
If your car stereo does not have an active +12 volt lead
when it is turned on, you can either install an auxiliary
switch, or you can tap into an ignition lead. However, if you
choose the ignition option, your amplifier will turn on every
time you start your car.
For floating ground head units, connect the positive (+)
speaker wires only. Do not connect the negative (-) speaker
wires.
For common ground head units, connect both the positive
(+) and negative (-) speaker wires.
Always connect the "signal ground wire" to chassis ground
when using the high-level inputs.
Do not connect high-level input wires if you are using the
low-level input RCA jacks.
www.insignia-products.com
Insignia NS-A1000 Car Stereo Amplifier