UL De 30 Manual De Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 4

Required Tools for Installation
- Phillips Screwdriver
- 1/4" Nut driver / Ratchet
- 7/16 I'
Nut driver / Ratchet
Supplied Hardware
Description
(4)
(2)
(4)
(6)
1/4-20 Nylon Insert
7/16" Hex Nut
Blower (fig. 20)
#10-24 3.5" Brackets
Long Phillips Screw (fig. 15 & 16)
(_ #8-18 Wide Head Transition Duct
Phillips Screw (fig. 18)
#8-18 Black Plenum and Wire
%" Hex Head Screw Box (fig. 17 & 21)
Countertop
(2) Hold Down Bracket (fig. 15 & 16)
3
(8.3 cm)
q_
1 1 II
(27.9cm)
Wall Outlet Location
Install the electric wall outlet within the shaded area.
cL
I _1 11 1/2"
'_- 3/4,-, (29.2cm)
6" 8
(15.2cm) (22.2cm)
Figure 3B - 30" MODEL
ELECTRICAL OUTLET INSTALL DIMENSIONS
Provide an Adequate Gas Supply
This cooktop is designed to operate on natural gas at 4"
of manifold pressure only.
A pressure regulator must be connected
in series with the manifold on the cooktop and must
remain in series with the supply line.
For proper operation, the maximum inlet pressure to the
regulator must be no more than 14" of water column
(W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1" (or 2.5 kPa) greater than the regulator manifold
pressure setting. The regulator is set for 4" of manifold
pressure, the inlet pressure must be at least 5".
The gas supply line to the range should be 1/2" or 3/4"
pipe.
Figure 3A - 36" MODEL
ELECTRICAL OUTLET INSTALL DIMENSIONS