Descargar Imprimir esta página

Tc 4. Intended Use; Tc 5. Inspection, Handling And Transport - ThermoKey TMC Serie Manual Tecnico

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
ThermoKey
Heat Exchange Solutions
TC 3.6
Each product is supplied with EC Declaration of Incorporation
TC 3.7
Additional product documentation, consisting of catalogues, guides and technical bulletins, is provided directly
by ThermoKey and is available on the website www.thermokey.com.
CATALOGUES – http://www.thermokey.com/Cataloghi.aspx
MANUALS – http://www.thermokey.com/Manuali.aspx

TC 4. Intended use

TC 4.1
The model must be used exclusively for the purpose indicated below, otherwise its use is considered improper and
exempts the manufacturer from any responsibility.
TC 4.2
TKSmart series microchannel condensers are used as condensers in HVAC&R applications. The product is not
provided with a dedicated subcooling circuit. The thermodynamic performances are defined in accordance with
EN 327.
TC 4.3
The standard model is equipped with electrical fans not suitable to withstand additional static pressures.
TC 4.4
If in doubt regarding the intended use of the product, please contact the Manufacturer.

TC 5. Inspection, handling and transport

TC 5.1
Upon receipt of the product, check the integrity of the packaging and of the product; immediately notify any damage
to the carrier. The packaging is manufactured in accordance with the model, the appropriate means of transport and
the correct handling.
TC 5.2
During transport and handling of the packed product, avoid any excessive and improper stress on the package.
TC 5.3
During transport and handling of the packed product, use appropriate protection to avoid any injury caused by
packaging parts such as nails, boards or cardboards and parts of the product such as fins or casing parts
(see DPI Technical Manual Section I chapter IG 6).
09
MT TC R MC EN 04 2017
TC 5.4
Unpack the product as close as possible to its installation site (see also installation and commissioning). In general the
product must not be transported or handled without its original packaging.
TC 5.5
During handling of the unpacked unit for installation, use protection to prevent injuries caused by sharp edges such as fins or
casing parts (see DPI Technical Manual Section I chapter IG 6).
Please find below the unpacking procedure:
1
TKSmart as shipped
3
Remove the 4 screws
MT TC R MC EN 04 2017
Technical Manual TC Instruction and technical data
2
Remove the carton box
4
Please read the documentation attached for
more information
10

Publicidad

Capítulos

loading

Productos relacionados para ThermoKey TMC Serie