Lectern Wheel Setup - Denon Professional LECTERN ACTIVE-W Guia Del Usuario

Lectern Wheel Setup

This wheel set can be attached to your Lectern Active-W to make moving it between locations
quick and easy.
To attach the wheels to your Lectern Active-W:
1. Carefully tilt your Lectern Active-W forward on its front side to allow access to the bottom
of the base. See image below for reference.
2. Using a screwdriver, remove the top two rubber foot pads from the Lectern Active-W
base. These screws can be set aside.
3. Place the wheel so the hole in its base is matched up with the hole in the Lectern Active-
W base where the rubber foot was attached.
4. Place the rubber foot pad back over the wheel, again making sure to properly align the
screw holes.
5. Use the included longer-length screws to secure the rubber foot pads and wheels to the
Lectern Active-W base. See image below for reference.
Note: Do not use the screws removed from the rubber foot pad, which are not long
enough to properly secure the wheels to the Lectern Active-W base. Use only the longer-
length screws included with the wheel set.
6. Carefully tilt Lectern Active-W upright.
To move Lectern Active-W once the wheels have been installed, simply tilt the unit toward
you and roll Lectern Active-W.
5