These accessories were available when this lawn mower was produced, They are also
availabte at most Sears retail outlets and sewice centers, Most Sears stores can also order
repair parts for you, when you provide the model number of your lawn mower. Some of these
accessories may not apply to your lawn mower.
LAWN MOWER PERFORMANCE
CLIPPING D ER.ECTO.
FOR. REAR D!SC,H,ARG E LAWN MOWERS
GRASS CATCHERS
FOR
REAR DISCHARGE
LAWN MOWERS
LAWN MOWER MAINTENANCE
MULCHER KITS
GRASS CATCHERS
FOR
SIDE DISCHARGE
LAWN MOWERS
STABILIZER
GAS CANS
MUFFLERS
............. _,,,,,,,,_...................
,,,
BELTS
BLADES
AIR FILTERS
BLADE ADAPTERS
WHEELS
SPARK PLUGS
ENGINE OIL
Read these instructions and this manual in its
entirety before you attempt to assemble or
operate your new lawn mower. Your new lawn
mower has been assembled at the factor,] with
the exception of those parts left unassembled
for shipping purposes. All parts such as nuts,
washers, bolts, etc., necessary to complete [he
assembly have been placed in the parts bag.
To ensure safe and proper operation of your
lawn mower, atl parts and hardware you
assemble must be tightened securely. Use the
correct toots as necessary to ensure proper
tightness,
TO REMOVE LAWN MOWER FROM
CARTON
= Remove loose parts included with mower°
o Cut down two end comers of carton and lay
end panel down flato
o Remove all packing materials except
padding between upper and lower handie
and padding holding operator presence
control bar to upper handle.
= Roll lav_nmower out of carton and check
carton thoroughly for additional loose parts_
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD HANDLE
IMPORTANT: Un fold handles carefutfy so as
notto pinchor damage controlcables,
° Raise handles untillower handle section
locksintoplace in mowingposition.
o Remove protective padding, raise upper
handle section into place on lower handle
and tighten both handle knobs.
o Remove handle padding holding operator
presence control bar to upper handle.
o Your lawn mower handle can be adjusted
for your mowing comfort, Refer to "Adjust
Handle" in the Service and Adjustment
section of this manual,