Artisan Technology Group IKA Serie Instrucciones De Manejo página 17

Commissioning
¢
Function keys (see page 4)
"Power" key (1)
¢
¢
Note: The device must first be switched on at the on/off switch on
the right side of the device.
Note: The device is not dead or deenergised until the on/off switch
has been switched to off (right side of device)!
Lift position key "L" (2)
L
L
Lift position key "M" (3)
M
M
Rotating knob (4)
Setting the speed
¢
Note: When you select the speed > 100 rpm, smooth start is auto-
matically activated.
Start / Stop Rotation drive
¢
¢
Timer key (5)
¢
Note: Once the timer has run out, there is a beep, the rotation fi-
nishes and the lift goes up.
¢
Int key (6)
¢
Note: In interval mode the maximum speed is limited to 200 rpm.
16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Display (see page 4)
Display "REMOTE" (10)
Display "888 rpm" (20)
Fig.16
Display (30)
Display "TIMER" (40)
Note: With the software "
off the heating bath once the timer has run out.
Display "INT" (50)
Display "E01" (20)
Setting the lower end stop
CAUTION!
M
Note: The evaporator piston should be 2/3 immersed in the heating
bath.
L
Note: The path is limited from 0 – 6 cm.
Fig.17
Check that the limit stop is functioning properly:
¢
Filling the evaporator piston
¢
Note: CAUTION! The maximum allowed load (evaporator piston
and contents) is 3 kg.
soft
soft", RV 10 digital can also switch
Fig.18
M