Craftsman 917.377282 El Manual Del Propietario página 14

CAUTION; BEFOREPERFORMING
ANY SERVICEORADJUSTMENTS:
o Releasecontroibar.
o .Makesure the bladeand all moving
palls havecompletelystopped°
o Disconnect s park plug wire from
sparkplug and place whereit cannot
comein contactwith plug,
LAWN MOWER
TO ADJUSTCU'FTINGHEIGHT
See "TOADJUSTCUTTINGHEIGHT *'in
the Operationsectionof this manuaL
REAR DEFLECTOR
The reardeflector,attachedbetweenthe
rear wheelsof your lawn mower,is
:
provided to minimize the possibility that
objects will be t.hrown out the rear of the:
lawn mower into the operator's mowing
position, If the rear deflector becomes
damaged, it should be replaced..
TO REMOVE/REPLACE DRIVE BELT
o Remove drive cover. Remove belt by
pusI_ing down on gear case pulley and
.rolling belt off it.
° Turn lawn mower on its side with
carburetor and fuel cap up.
° Remove blade.
= Remove debris shield.
o Remove belt from engine pulley on
crankshaft.
° Install new belt by reversing above
steps,
° Always use factory approved belt to
assure fit and long life,
,, To change from medium low to medium
high position, the upper and lower handle
sections will have to be turned over,
° Remove the cable clips,
o Remove the controls and operator presence
control bar from the upper handle°
o Remove the starter rope guide from the
lower handle°
o Remove hairpin cotters,.
o Disconnect the lower handle from the
handle brackets,.
o Turn the handle over and reassemble the
hairpin cotters that have been removed,
,, Reassemble the starter rope guide,
o Reassemble the controls and the operator
presence control bar to the upper handle,
CAUTION:
The operator' presence
control bar must pivot freely to permit
blade brake engagement when control bar
is re_eased. Do not over tighten the
fasteners holding the controls to the upper
handle,
,, To change from medium low to high
position onty the upper handle section
will have to be turned over°
° To change from medium Iow to low
position, only the lower handle section
will have to be turned over.
Shipping position
Medium ]ow Medium high
Drive
cover Belt
Push .t
down
TO ADJUST HANDLE
Your lawn mower handle can be raised or
lowered for your mowing comfort.. Four
(4) positions are available: high, medium
high, medium low and low. Handles are
shipped mounted in the medium Iow
position.
High
Low
14